Network Interface Gigabitethernet Status Page - Allen-Bradley Stratix 5100 User Manual

Network Interface GigabitEthernet Status Page

Use this page to review the status for the GigabitEthernet interface.
Figure 37 - Network Interface GigabitEthernet Status Page
Table 16 - GigabitEthernet Status Parameter Descriptions
Parameter
Configuration
Software Status
Hardware Status
Maximum Rate
Duplex
Interface Statistics
Interface Resets
No Carrier
Lost Carrier
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Stratix 5100 Device Manager Parameter Definitions
Description
Indicates whether the interface has been enabled or disabled by the operator.
Indicates whether the line protocol for the interface is up or down.
The rate setting for the Ethernet interface, either 10 Mbps or 100 Mbps.
The duplex setting for the Ethernet interface, either half or full.
The number of times an interface has been completely reset.
The number of times the carrier was not present during the transmission.
The number of times the carrier was lost during transmission.
Chapter 4
91