Inter-Access Point Protocol Messages; Local Authenticator Messages - Allen-Bradley Stratix 5100 User Manual

Table 6 - Subsystem Messages (Continued)
Message
SOAP_FIPS-2-SELF_TEST_RAD_FAILURE:
"RADIO crypto FIPS self test failed at %s
on interface %s %d."
SOAP_FIPS-2-SELF_TEST_IOS_SUCCESS: "IOS
crypto FIPS self test passed."
SOAP_FIPS-2-SELF_TEST_RAD_SUCCESS:
"RADIO crypto FIPS self test passed on
interface %s %d."
DOT11-6-MCAST_DISCARD: "%s mode multicast
packets are discarded in %s multicast
mode."
Inter-Access Point Protocol
Messages
Message
DOT11-6-STANDBY_ACTIVE: "Standby to
Active, Reason = %s (%d)."
DOT11-6-STANDBY_REQUEST: "Hot Standby
request to shutdown radios from %e."
DOT11-6-ROGUE_AP: "Rogue AP %e reported.
Reason: %s."
Local Authenticator
Messages
Message
RADSRV-4-NAS_UNKNOWN: Unknown
authenticator: [ip-address]
RADSRV-4-NAS_KEYMIS: NAS shared key
mismatch.
RADSRV-4_BLOCKED: Client blocked due to
repeated failed authentications
DOT1X-SHIM-6-AUTH_OK: "Interface %s
authenticated [%s]."
DOT1X-SHIM-3-AUTH_FAIL: "Interface %s
authentication failed."
DOT1X-SHIM-3-INIT_FAIL: "Unable to init -
%s."
Explanation
SOAP FIPS self test on radio crypto routine failed.
SOAP FIPS self test passed.
SOAP FIPS self test passed on a radio interface.
The access point configured as a workgroup bridge and
drops infrastructure mode multicast packets in client
mode and drops client mode multicast packets in
infrastructure mode.
Explanation
The access point is transitioning from standby mode to
active mode for the indicated reason.
The indicated standby access point has requested that this
access point shut down its radio interfaces because a
failure has been detected on one of this access point's
radio interfaces.
A station has reported a potential rogue access point for
the indicated reason.
Explanation
The local RADIUS server received an authentication
request but does not recognize the IP address of the
network access server (NAS) that forwarded the request.
The local RADIUS server received an authentication
request but the message signature indicates that the
shared key text does not match.
A user failed authentication the number of times
configured to trigger a block, and the account been
disabled.
The 802.1x authentication was successful.
The 802.1x authentication failed to the attached device.
An error occurred during the initialization of the shim
layer.
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Error and Event Messages Appendix C
Recommended Action
Check radio image.
None
None
Recommended Action
None.
None.
None.
Recommended Action
Make sure that every access point on your
wireless LAN is configured as a NAS on your
local RADIUS server.
Correct the shared key configuration on
either the NAS or on the local RADIUS server.
Use the
clear radius local-
server user username
privileged EXEC command to unblock the
user, or allow the block on the user to expire
by the configured lockout time.
None
Check the configuration of the 802.1x
credentials on the client as well as the
RADIUS server.
589