Cli Configuration Example; Configuring Management Frame Protection - Allen-Bradley Stratix 5100 User Manual

Chapter 13 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
Configuring Management
Frame Protection
396
d. Check the CCKM check box.
7. Click Apply.

CLI Configuration Example

This example shows CLI commands that are equivalent to the steps listed in the
Configuring Access Points to Support Fast Secure Roaming on page
AP# configure terminal
AP(config)# dot11 ssid fastroam
AP(config-ssid)# authentication network-eap
eap_methods
AP(config-ssid)# authentication key-management cckm
AP(config-ssid)# exit
AP(config)# interface dot11radio0
AP(config-if)# encryption mode ciphers ckip-cmic
AP(config-if)# ssid fastroam
AP(config-if)# exit
AP(config)# end
In this example, the SSID fastroam is configured to support Network EAP and
CCKM, the CKIP-CMIC cipher suite is enabled on the 2.4 GHz radio
interface, and the SSID fastroam is enabled on the 2.4 GHz radio interface.
For information about other keywords for the show spanning-tree privileged
EXEC command, see publication
Aironet Access Points and
Management Frame Protection operation requires a WDS and is available only
on 32 Mb platforms. MFP is configured at the WLSE, but you can configure
MFP on an access point and WDS manually.
If a WLSE is not present, then MFP cannot report detected intrusions and so has
TIP
limited effectiveness. If a WLSE is present, you can perform the configuration
from the WLSE.
For complete protection, you can also configure an MFP access point for Simple
Network Transfer Protocol (SNTP).
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Cisco IOS Command Reference for Cisco
Bridges.
394: