Configuring Cdp; Default Cdp Configuration; Configuring The Cdp Characteristics - Allen-Bradley Stratix 5100 User Manual

Chapter 18

Configuring CDP

Configuring CDP
500
This section contains CDP configuration information and procedures:

Default CDP Configuration

This table lists the default CDP settings.
Table 108 - Default CDP Configuration
Feature
CDP global state
CDP interface state
CDP holdtime (packet holdtime in seconds)
CDP timer (packets sent every x seconds)

Configuring the CDP Characteristics

You can configure the CDP holdtime (the number of seconds before the access
point discards CDP packets) and the CDP timer (the number of seconds
between each CDP packets the access point sends).
Beginning in Privileged Exec mode, follow these steps to configure the CDP
holdtime and CDP timer.
1. Enter global configuration mode.
configure terminal
2. (Optional) Specify the amount of time you want a receiving device to hold
the information sent by the device before discarding it.
The range is from 10...255 s; the default is 180 s.
cdp holdtime seconds
3. (Optional) Set the transmission frequency of CDP updates in seconds.
The range is from 5...254 s; the default is 60 s.
cdp timer seconds
4. Return to Privileged Exec mode.
end
Use the form of the CDP commands to return to the default settings.
no
This example shows how to configure and verify CDP characteristics:
AP# configure terminal
AP(config)# cdp holdtime 120
AP(config)# cdp timer 50
AP(config)# end
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Default Setting
Enabled
Enabled
180
60