Using Cli - Allen-Bradley Stratix 5100 User Manual

Chapter 21 Troubleshooting

Using CLI

564
The System Configuration screen appears.
7. Click the Reset to Defaults or Reset to Defaults (Except IP).
8. If you want to retain a static IP address, choose Reset to Defaults (Except
IP).
9. Click Restart.
The system restarts.
10. After the wireless device restarts, you must reconfigure the wireless device
by using the web browser interface or CLI commands.
The default username is blank and the password is wirelessap, that is
case-sensitive.
Follow the steps below to delete the current configuration and return all wireless
device settings to the factory defaults by using CLI commands.
1. Open CLI by using a Telnet session or a connect to the wireless device by
using the console port.
2. Restart the wireless device by removing power and reapplying power.
Let the wireless device start up until the command prompt appears and the
wireless device begins to inflate the image. This can take a minute.
When you see these lines on CLI, press Esc.
Loading "flash:/c350-k9w7-mx.v122_13_ja.20031010/
c350-k9w7-mx.v122_13_ja.20031010"
...################################################
###########################
###################################################
#############################
###################################################
#############################
####################
3. At the ap: prompt, enter the
Flash.
ap: flash_init
Initializing Flash...
flashfs[0]: 142 files, 6 directories
flashfs[0]: 0 orphaned files, 0 orphaned
directories
flashfs[0]: Total bytes: 7612416
flashfs[0]: Bytes used: 3407360
flashfs[0]: Bytes available: 4205056
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
command to initialize the
flash_init