Configuring Radius; Default Radius Configuration; Identifying The Radius Server Host - Allen-Bradley Stratix 5100 User Manual

Chapter 14 Configuring RADIUS and TACACS+ Servers
410
There is more than one type of EAP authentication, but the access point behaves
the same way for each type: it relays authentication messages from the wireless
client device to the RADIUS server and from the RADIUS server to the wireless
client device. See Assigning Authentication Types to an SSID on page 359
instructions on setting up client authentication by using a RADIUS server.

Configuring RADIUS

This section describes how to configure your access point to support RADIUS.
At a minimum, you must identify the host or hosts that run the RADIUS server
software and define the method lists for RADIUS authentication. You can
optionally define method lists for RADIUS authorization and accounting.
A method list defines the sequence and methods to be used to authenticate, to
authorize, or to keep accounts on a user. You can use method lists to designate
one or more security protocols to be used, thus ensuring a back-up system if the
initial method fails. The software uses the first method listed to authenticate, to
authorize, or to keep accounts on users; if that method does not respond, the
software selects the next method in the list. This process continues until there is
successful communication with a listed method or the method list is exhausted.
You can access and configure a RADIUS server before configuring RADIUS
features on your access point.
The RADIUS server CLI commands are disabled until you enter the
TIP
new-model

Default RADIUS Configuration

RADIUS and AAA are disabled by default. To prevent a lapse in security, you
cannot configure RADIUS through a network management application. When
enabled, RADIUS can authenticate users accessing the access point through CLI.

Identifying the RADIUS Server Host

Access point-to-RADIUS-server communication involves several components:
• Host name or IP address
• Authentication destination port
• Accounting destination port
• Key string
• Timeout period
• Retransmission value
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
command.
for
aaa