Example 3: Eap Authentication - Allen-Bradley Stratix 5100 User Manual

Chapter 5 Configure the Stratix 5100 WAP Using the Command-Line Interface
188

Example 3: EAP Authentication

This example shows part of the configuration that results from using the Security
page to create an SSID called
and assigning the SSID to VLAN 30:
The following warning message appears if your radio clients are using EAP-
IMPORTANT
FAST and you don't include open authentication with EAP as part of the
configuration:
SSID CONFIG WARNING: [SSID]: If radio clients are using EAP-FAST, AUTH OPEN
with EAP must be configured.
dot11 ssid eap_ssid
vlan 30
authentication open eap eap_methods
authentication network-eap eap_methods
!
interface Dot11Radio0/1
no ip address
no ip route-cache
!
encryption vlan 30 mode wep mandatory
!
ssid eap_ssid
!
speed basic-1.0 basic-2.0 basic-5.5 basic-11.0
rts threshold 2312
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface Dot11Radio0/1.30
encapsulation dot1Q 30
no ip route-cache
bridge-group 30
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
, excluding the SSID from the beacon,
eap_ssid