Configuring Access Points To Use The Wds Device - Allen-Bradley Stratix 5100 User Manual

Chapter 13 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
390

Configuring Access Points to Use the WDS Device

To participate in WDS, infrastructure access points run the same version of IOS
as the one that WDS runs.
Follow these steps to configure an access point to authenticate through the WDS
device and participate in WDS.
1. Browse to the Wireless Services Summary page.
2. Click AP to browse to the Wireless Services AP page.
This Wireless Services page appears.
Figure 104 - Wireless Services AP Page
3. Click Enable for the Participate in SWAN Infrastructure setting.
4. (Optional) If you use a WLSM switch module as the WDS device on your
network, choose Specified Discovery and enter the IP address of the
WLSM in the entry field.
When you enable Specified Discovery, the access point immediately
authenticates with the WDS device instead of waiting for WDS
advertisements. If the WDS device that you specify does not respond, the
access point waits for WDS advertisements.
5. In the Username field, enter a username for the access point.
This username must match the username that you create for the access
point on your authentication server.
6. In the Password field, enter a password for the access point, and enter the
password again in the Confirm Password field.
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014