Applying The Credentials Profile To An Ssid Used For The Uplink; Creating And Applying Eap Method Profiles - Allen-Bradley Stratix 5100 User Manual

Creating and Applying EAP
Method Profiles

Applying the Credentials Profile to an SSID Used for the Uplink

If you have a repeater access point in your wireless network and are using the
802.1X supplicant on the root access point, you must apply the 802.1X
supplicant credentials to the SSID the repeater uses to associate with and
authenticate to the root access point.
Beginning in the privileged EXEC mode, follow these steps to apply the
credentials to an SSID used for the uplink:
1. Enter global configuration mode.
configure terminal
2. Enter the 802.11 SSID.
The SSID can consist of up to 32 alphanumeric characters. SSIDs are case
sensitive. The first character cannot contain the !, #, or ; character. The characters
+, ], /, ", TAB, and trailing spaces are invalid characters for SSIDs.
dot11 ssid ssid
3. Enter the name of a preconfigured credentials profile.
dot1x credentials profile
4. Exits the dot1x credentials configuration submode
end
5. Save your entries in the configuration file. This is optional.
copy running config startup-config
The following example applies the credentials profile test to the
on a repeater access point.
repeater-ap>enable
Password:xxxxxxx
repeater-ap#config terminal
Enter configuration commands, one per line. End
with CTRL-Z.
repeater-ap(config-if)#dot11 ssid testap1
repeater-ap(config-ssid)#dot1x credentials test
repeater-ap(config-ssid)#end
repeater-ap(config)
You can optionally configure an EAP method list to enable the supplicant to
recognize a particular EAP method. See
Profiles for the 802.1X Supplicant on page 370
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Configure the Stratix 5100 WAP Using the Command-Line Interface
Creating and Applying EAP Method
Chapter 5
ssid testap1
197