Mini Ios Messages; Access Point/Bridge Messages; Cisco Discovery Protocol Messages; External Radius Server Error Messages - Allen-Bradley Stratix 5100 User Manual

Mini IOS Messages

Message
MTS-2-PROTECT_PORT_FAILURE: An attempt to
protect port [number] failed
MTS-2-SET_PW_FAILURE: Error %d enabling
secret password.
Saving this config to nvram may corrupt
any network management or security files
stored at the end of nvram. Continue?
[no]:
Access Point/Bridge
Messages
Message
APBR-4-SEND_PCKT_FAILED:
Packet on port ifDescr (error=
errornum)errornum: status error number
Check for sources of noise or
interference.
If this message appears continuously,
reboot the access point.
Cisco Discovery Protocol
Messages
Message
CDP_PD-2-POWER_LOW: %s - %s %s (%e)
External Radius Server Error
Messages
Message
RADUYS:response-authenticator decrypt
fail, paklen 32
Explanation
Initialization failed on attempting to protect port.
Initialization failed when the user attempted to enable a
secret password.
This warning message appears on the access point CLI
interface while saving configuration changes through CLI.
This is due to insufficient space in flash memory. When a
radio crashes, .rcore files are created. These files indicate a
firmware or a hardware problem in the radio, although a
hardware problem is less likely.
Explanation
HASH(0x2096974)
Failed to Send
APBR-6-DDP_CLNT_RESET: Detected probable reset of
hosthost: host MAC address HASH(0x2080f04)
Explanation
The system is not supplied with sufficient power.
Explanation
This error message means that there is a mismatch in the
RADIUS shared key between the RADIUS server and the
access point.
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Error and Event Messages Appendix C
Recommended Action
None.
None
This warning message can be prohibited by
removing the rcore files generated in flash
memory. The rcore files have a .rcore
extension. The files can be deleted because
they simply show that the radio went down
at some point. The .rcore files can be listed on
CLI session and appear similar to this:
r15_5705_AB50_A8341F30.rcore
Recommended Action
The access point or bridge failed to send a
packet. This condition can be seen if there is
external noise or interference.
The access point or bridge detects that
another infrastructre device has restarted.
Recommended Action
Reconfigure or replace the source of inline
power.
Recommended Action
Make sure that the shared key used on the
RADIUS server and the access point are the
same.
591