Radio Tracking; Fast Ethernet Tracking - Allen-Bradley Stratix 5100 User Manual

Chapter 7 Configuring Radio Settings

Radio Tracking

Fast Ethernet Tracking

246
You can configure the access point to track or monitor the status of one of its
radios. It the tracked radio goes down or is disabled, the access point shuts down
the other radio. If the tracked radio comes up, the access point enables the other
radio.
• To track radio 0, enter the following command:
# station-role root access-point fallback track d0
shutdown
• To track radio 1, enter the following command:
# station-role root access-point fallback track d1
shutdown
This command is not supported by 802.11n series access points, you must
use the following command in the radio interface configuration mode:
# station-role root access-point fallback shutdown
You can configure the access point for fallback when its Ethernet port is disabled
or disconnected from the wired LAN. You configure the access point for fast
Ethernet tracking as described in the
page 245.
TIP Fast Ethernet tracking does not support the Repeater mode.
• To configure non-802.11n access points for Fast Ethernet tracking, in the
radio interfaces configuration mode enter the following command:
# station-role root access-point fallback track fa
0
• To configure 802.11n access points for Gigabit Ethernet tracking, in the
radio interfaces configuration mode enter the following command:
# station-role root fallback shutdown
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Universal Workgroup Bridge Mode on