Software Upgrade Http Page - Allen-Bradley Stratix 5100 User Manual

Wireless access point/workgroup bridge

Hide thumbs Also See for Stratix 5100:

Table of Contents

Software Upgrade HTTP Page

An HTTP upgrade requires you to load the image into the access point memory.

If there is not enough system memory for an HTTP upgrade, the upgrade fails. If

it fails, try using TFTP upgrade or upgrading HTTP again after disabling the

radio interfaces, shutting off high memory usage features (such as WDS), and

Figure 81 - Software Upgrade HTTP Page

Table 66 - Software HTTP Upgrade Page Parameter Descriptions

System Software Filename

The software that is installed on the system.

System Software Version

The version of Cisco IOS software that is running on the access point.

Bootloader Version

The version of bootloader that is installed. The bootloader does not change when the

system image is changed.

Upgrade System Software

To install a newer version of Cisco IOS software, follow these steps:

1. Insert the correct path and filename of the new system software tar file.

2. Go to Cisco.com and download the newest system software version to your local

3. Click Browse, locate the new system software file.

4. Click Upgrade to copy the file to the access point.

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014

Stratix 5100 Device Manager Parameter Definitions

Upgrades can take several minutes to complete and can cause the access point to