Displaying The Time And Date Configuration; Configuring The Time Zone - Allen-Bradley Stratix 5100 User Manual

Chapter 6 Administering the WAP Access
232
2. Verify your entries.
show running-config
3. (Optional) Save your entries in the configuration file.
copy running-config startup-config
This example shows how to manually set the system clock to 1:32 p.m. on July 23,
2001.
AP# clock set 13:32:00 23 July 2001

Displaying the Time and Date Configuration

To display the time and date configuration, use the
privileged EXEC command.
The system clock keeps an authoritative flag that shows whether the time is
authoritative (believed to be accurate). If the system clock has been set by a
timing source such as NTP, the flag is set. If the time is not authoritative, it is used
only for display purposes. Until the clock is authoritative and the authoritative
flag is set, the flag prevents peers from synchronizing to the clock when the peers'
time is invalid.
The symbol that precedes the
• *
Time is not authoritative.
• (blank) Time is authoritative.
• .
Time is authoritative, but NTP is not synchronized.

Configuring the Time Zone

Beginning in privileged EXEC mode, follow these steps to manually configure
the time zone:
1. Enter global configuration mode.
configure terminal
2. Set the time zone.
The wireless device keeps internal time in universal time coordinated
(UTC), so this command is used only for display purposes and when the
time is manually set.
• For
, enter the name of the time zone to be displayed when
zone
standard time is in effect. The default is UTC.
• For
hours-offset
• (Optional) For
UTC.
clock timezone zone hours-offset [minutes-offset]
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
show clock [detail]
display has this meaning:
show clock
, enter the hours offset from UTC.
, enter the minutes offset from
minutes-offset