System Configuration Page - Allen-Bradley Stratix 5100 User Manual

System Configuration Page

This is where the system configuration information can be found. On this page,
you can load new configuration files, pull your show-tech information, reset the
device, and adjust PoE settings.
Figure 83 - System Configuration Page
Table 68 - Software System Configuration Parameter Descriptions
Parameter Description
Current Startup Right click on this link to save the config.txt file to your local hard disk. You can then edit
Configuration File the file and configure the access point as you wish.
Use the Load New Startup Configuration File feature to upload the new file to any access
point you want configured the same.
Load New Startup Browse to the location where you stored the config.txt file you saved using the Current
Configuration File Startup Configuration File feature.
Click Load to upload the new file to any access point you want configured the same. The
access point reboots when the new configuration is loaded.
Technical Support The show-tech command that pulls a great deal of system information that is very
Information helpful in determining what is wrong with a product. Your technical support staff requests
this information to begin troubleshooting the device.
Right click on this link to save the tech-support information to your local hard disk. You
can then e-mail this information to your technical support staff to assist them in
configuring your access point.
Reset to Factory Defaults Returns all access point settings to their factory defaults. The IP address is set to DHCP.
Click Reset to Defaults to cause the access point to restart. The default password for the
access point is wirelessap.
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Stratix 5100 Device Manager Parameter Definitions Chapter 4
169