Defining The Message Severity Level - Allen-Bradley Stratix 5100 User Manual

Chapter 21 Configuring System Message Logging
554

Defining the Message Severity Level

You can limit messages displayed to the selected device by specifying the
severity level of the message, that are described in
Specifying a level causes messages at that level and numerically lower levels to
be displayed at the destination.
Beginning in privileged EXEC mode, follow these steps to define the message
severity level:
1. Enter global configuration mode.
configure terminal
2. Limit messages logged to the console.
By default, the console receives debugging messages and numerically lower
levels (see Table 115 on page
logging console level
3. Limit messages logged to the terminal lines.
By default, the terminal receives debugging messages and numerically
lower levels (see Table 115 on page
logging monitor level
4. Limit messages logged to the syslog servers.
By default, syslog servers receive informational messages and numerically
lower levels (see Table 115 on page
For complete syslog server configuration steps, see
Syslog Servers on page
logging trap level
5. Return to privileged EXEC mode.
end
6. Verify your entries.
show running-config
or
show logging
7. (Optional) Save your entries in the configuration file.
copy running-config startup-config
• To disable logging to the console, use the
configuration command.
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Table 115 on page
555).
555).
555).
558.
no logging console
555.
Configuring UNIX
global