Network Page - Allen-Bradley Stratix 5100 User Manual

Wireless access point/workgroup bridge

Hide thumbs Also See for Stratix 5100:

Table of Contents

Stratix 5100 Device Manager Parameter Definitions

Network Page

The Network page contains information about the network map and adjacent

nodes. The Network Interface page provides the status of GigabitEthernet and

Radio-802.11b, Radio-802.11a, or Radio-802.11g interfaces, depending on the

radio you have installed on the access point.

Use the Network Map page to display information for any device on your wireless

network. Unlike the Association page, the Network Map page does not list wired

devices on your LAN.

Choose Enable or Disable for Network Map capabilities. If you select Enable, it is

best to switch back to the Disable default before leaving the page because the time

to discover the network can greatly increase the system load.

Figure 34 - Network Map

Table 13 - Stratix 5100 Network Map Parameter Descriptions

The Network Map page provides information for any device on your wireless network. The

Network Map page does not list wired devices on your LAN. If you need to see what wired

devices you have on a LAN, see

Choose Enable to view the network map. If you choose Enable, switch back to Disable

before leaving the page because the time to discover the network can greatly increase the

system load.

The unique identifier assigned to the device by the manufacturer.

The IP address of the port.

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014

Association Page on page