Limiting Syslog Messages Sent To The History Table And To Snmp - Allen-Bradley Stratix 5100 User Manual

Chapter 21 Configuring System Message Logging
556

Limiting Syslog Messages Sent to the History Table and to SNMP

If you have enabled syslog message traps to be sent to an SNMP network
management station by using the
configuration command, you can change the level of messages sent and stored
in the access point history table. You can also change the number of messages
that are stored in the history table.
Messages are stored in the history table because SNMP traps are not
guaranteed to reach their destination. By default, one message of the level
and numerically lower levels (see
warning
in the history table even if syslog traps are not enabled.
Beginning in privileged EXEC mode, follow these steps to change the level
and history table size defaults:
1. Enter global configuration mode.
configure terminal
2. Change the default level of
sent to the SNMP server.
See Table 115 on page 555
By default, warnings, errors, critical, alerts, and emergencies messages are
sent.
logging history level
Specify the number of
table. The default is to store one message. The range is 1...500 messages.
logging history size number
3. Specify the number of syslog messages that can be stored in the history
table.
The default is to store one message. The range is 1 ...500 messages.
logging history size number
4. Return to privileged EXEC mode.
end
5. Verify your entries.
show running-config
6. (Optional) Save your entries in the configuration file.
copy running-config startup-config
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
snmp-server enable trap
Table 115 on page
messages stored in the history file and
syslog
for a list of level keywords.
messages that can be stored in the history
syslog
global
555) are stored