Software Auto Upgrade Messages - Allen-Bradley Stratix 5100 User Manual

Appendix C Error and Event Messages
Table 1 - Conventions for System Error Messages (Continued)
Message Component Description
Action Flags Internal to the code for additional action to display. 0—No action flag
%d An integer number.
%e A MAC address.
%s A message string that provides more detail of the
error.
%x A hexadecimal number.
Software Auto Upgrade
Messages
Table 2 - Software Auto Upgrade Messages
Message
SW-AUTO-UPGRADE-2-FATAL_FAILURE: "Attempt to
upgrade software failed, software on flash may be
deleted. Please copy software into flash.
SW-AUTO-UPGRADE-7-DHCP_CLIENT_FAILURE: "%s": Auto
upgrade of the software failed."
SW-AUTO-UPGRADE-7-DHCP_SERVER_FAILURE: "%s": Auto
upgrade of the software failed."
SW-AUTO-UPGRADE-7_BOOT_FAILURE: "%s": Auto upgrade
of the software failed."
AUTO-INSTALL-4-STATION_ROLE: "%s": The radio is
operating in automatic install mode."
AUTO-INSTALL-4-IP_ADDRESS_DHCP: "The radio is
operating in automatic install mode and has set ip
address dhcp."
Error Message: AUTO-INSTALL-6_STATUS:
"%s" %s. RSSI=-%d dBm.: "The radio is
operating in install mode."
AVR_IMAGE_UPDATE-7-UPDATE_COMPLETE: "The AVR "$d"
firmware was successfully updated."
AVR_IMAGE_UPDATE-2-UPDATE_FAILURE: "The AVR "$d"
firmware is not current. Update error: "$s"."
AVR_IMAGE_UPDATE-4-UPDATE_SKIPPED: "AVR "$d" update
processing was skipped:"$s"."
AVR_IMAGE_UPDATE-4-UPDATE_START: "The system is
updating the AVR "$d" firmware. Please wait . . . "
582
Example
MSG-TRACEBACK—includes traceback with message
MSG-PROCESS—includes process information with message
MSG-CLEAR—indicates condition had cleared
MSG-SECURITY—indicates as security message
MSG-NOSCAN—suppresses EEM pattern screening
2450
000b.fcff.b04e
"Attempt to protect port 1640 failed."
0x001
This table explains the messages when you are upgrading the software.
Explanation
Auto upgrade of the software failed. Check to
see if the software has been deleted. Copy
software into the flash.
Auto upgrade of the software failed.
Auto upgrade of the software failed.
Auto upgrade of the software failed.
The radio is operating in automatic install
mode.
The radio is operating in automatic install
mode and is configured to receive an IP
address through DHCP.
The radio is operating in automatic install
mode.
The access point AVR firmware was
successfully updated.
The AVR firmware is not current and the
update failed
AVR update processing was skipped due to an
error.
The system is updating the AVR firmware.
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Recommended Action
Copy software before restarting the
unit.
Make sure that the DHCP client is
running.
Make sure that the DHCP server is
configured correctly.
Restart the unit. If the message appears
again, copy the error message exactly
as it appears and report it to your
technical support representative.
Use the station-role configuration
interface command to configure the
radio for a role other than install mode.
Use the station-role configuration
interface command to configure the
radio for a role other than install mode.
Use the station-role configuration
interface command to configure the
radio for a role other than install mode.
No action is required.
Copy the error message and report it to
your technical support representative.
No action is required.
No action is required.