Stp Configuration Examples; Root Bridge Without Vlans - Allen-Bradley Stratix 5100 User Manual

Chapter 9 Configuring Spanning Tree Protocol

STP Configuration Examples

310
5. Return to global configuration mode.
exit
6. Enable STP for the bridge group. You must enable STP on each bridge
group that you create with bridge-group commands.
bridge number protocol ieee
7. (Optional) Assign a priority to a bridge group. The lower the priority, the
more likely it is that the bridge becomes the spanning-tree root.
bridge number priority priority
8. Return to privileged EXEC mode.
end
9. Verify your entries.
show spanning-tree bridge
10. (Optional) Save your entries in the configuration file.
copy running-config startup-config
These configuration examples show how to enable STP on root and non-root
access points with and without VLANs:
•
Root Bridge without VLANs on page 310
•
Non-root Bridge without VLANs on page 312
•
Root Bridge with VLANs on page 313
•
Non-root Bridge with VLANs on page 315

Root Bridge without VLANs

This example shows the configuration of a root bridge with no VLANs
configured and with STP enabled:
hostname master-bridge-south
ip subnet-zero
!
bridge irb
!
interface Dot11Radio0
no ip address
no ip route-cache
!
ssid tsunami
authentication open
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014