Default System Message Logging Configuration; Disabling And Enabling Message Logging - Allen-Bradley Stratix 5100 User Manual

00:00:46: %LINK-3-UPDOWN: Interface Port-channel1,
changed state to up
00:00:47: %LINK-3-UPDOWN: Interface
GigabitEthernet0/1, changed state to up
00:00:47: %LINK-3-UPDOWN: Interface
GigabitEthernet0/2, changed state to up
00:00:48: %LINEPROTO-5-UPDOWN: Line protocol on
Interface Vlan1, changed state to down
00:00:48: %LINEPROTO-5-UPDOWN: Line protocol on
Interface GigabitEthernet0/1, changed state to down
2
*Mar 1 18:46:11: %SYS-5-CONFIG_I: Configured from
console by vty2 (10.34.195.36)
18:47:02: %SYS-5-CONFIG_I: Configured from console
by vty2 (10.34.195.36)
*Mar 1 18:48:50.483 UTC: %SYS-5-CONFIG_I:
Configured from console by vty2 (10.34.195.36)

Default System Message Logging Configuration

This table shows the default system message logging configuration.
Table 114 - Default System Message Logging Configuration
Feature
System message logging to the
console
Console severity
Logging buffer size
Logging history size
Timestamps
Synchronous logging
Logging server
Syslog server IP address
Server facility
Server severity

Disabling and Enabling Message Logging

Message logging is enabled by default. It must be enabled to send messages to
any destination other than the console. When enabled, log messages are sent
to a logging process, that logs messages to designated locations
asynchronously to the processes that generated the messages.
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Configuring System Message Logging
Default Setting
Enabled
Debugging (and numerically lower levels; see
4096 bytes
1 message
Disabled
Disabled
Disabled
None configured
Local7 (see Table 116 on page 560)
Informational (and numerically lower levels; see
Chapter 21
Table 115 on page 555)
Table 115 on page 555)
549