Cdp Page - Allen-Bradley Stratix 5100 User Manual

Wireless access point/workgroup bridge

Hide thumbs Also See for Stratix 5100:

Table of Contents

Stratix 5100 Device Manager Parameter Definitions

CDP Page

Cisco Discovery Protocol (CDP) is a device-discovery protocol that runs on all

Cisco network equipment. Each device sends identifying messages to a multicast

address, and each device monitors the messages sent by other devices.

Information in CDP packets is used in network management software such as

CiscoWorks2000. Use the CDP page to adjust the device's CDP settings.

Figure 62 - CDP Page

Table 46 - CDP Page Parameter Descriptions

Cisco Discovery Protocol (CDP)

Packet Hold Time (optional)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014

Select Disabled to disable CDP on the device; select Enabled to enable CDP on the

device. CDP is enabled by default.

The number of seconds other CDP-enabled devices need to consider the CDP

information valid. If other devices do not receive another CDP packet from the device

before this time elapses, the device has probably gone offline. The default value is

180. The packet hold time needs to always be greater than the value in the Packets

Sent Every field.