Enabling Videostream Support On Workgroup Bridges - Allen-Bradley Stratix 5100 User Manual

Wireless access point/workgroup bridge

Hide thumbs Also See for Stratix 5100:

Table of Contents

Configuring Repeater and Standby Access Points and Workgroup Bridge Mode

Enabling VideoStream

Support on Workgroup

VideoStream improves the reliability of an IP multicast stream by converting the

multicast frame, over the air, to a unicast frame. Cisco IOS Releases 15.2(2)JA

and later provide VideoStream support for wired devices connected to

workgroup bridges.

For access points running release 15.2(2)JA and later, the workgroup bridge is

added to the wireless LAN controller (WLC) multicast table, and the workgroup

bridge converts the VideoStream unicast frame into an Ethernet multicast frame

and sends it out to its wired clients.

Enter this command on the WLC to enable VideoStream for workgroup bridges:

config media-stream wired-client enable

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014