Using Debug Messages; Configuring Fast Secure Roaming; Requirements For Fast Secure Roaming - Allen-Bradley Stratix 5100 User Manual

Table 98 - Debug Commands
Command
debug wlccp ap
{mn | wds-discovery | state}
debug wlccp dump
debug wlccp packet
debug wlccp wds [aggregator |
authenticator | nm | state |
statistics]
debug wlccp wds authenticator {all |
dispatcher | mac-authen | process |
rxdata | state-machine | txdata}
Configuring Fast Secure
Roaming
Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services

Using Debug Messages

In privileged exec mode, use these debug commands to control the display of
debug messages for devices interacting with the WDS device:
Description
Use this command to turn on display of debug messages related to client devices (mn), the
WDS discovery process, and access point authentication to the WDS device (state).
Use this command to perform a dump of WLCCP packets received and sent in binary format.
Use this command to turn on display of packets to and from the WDS device.
Use this command and its options to turn on display of WDS debug messages. Use the statistics
option to turn on display of failure statistics.
Use this command and its options to turn on display of WDS debug messages related to
authentication.
After you configure WDS, access points configured for CCKM can provide fast,
secure roaming for associated client devices. This section describes how to
configure fast, secure roaming on your wireless LAN.

Requirements for Fast Secure Roaming

To configure fast secure roaming, you must have these items on your wireless
LAN:
• At least one access point, ISR, or switch (equipped with a WLSM)
configured as the WDS device
• Access points configured to participate in WDS
• Access points configured for fast, secure roaming
• An authentication server (or an access point, ISR, or switch configured as a
local authenticator)
• Cisco Aironet client devices, or Cisco-compatible client devices that
comply with Cisco Compatible Extensions (CCX) version 2 or later
For instructions on configuring WDS, refer to the
page 382.
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 13
Configuring WDS on
393