Defining Http Access; Configuring A System Name And Prompt - Allen-Bradley Stratix 5100 User Manual

Defining HTTP Access

Configuring a System Name
and Prompt
4. Verify your entries.
show running-config
5. (Optional) Save your entries in the configuration file.
copy running-config startup-config
The first part of the
clock summer-time
specifies when summer time begins, and the second part specifies when it ends.
All times are relative to the local time zone. The start time is relative to standard
time. The end time is relative to summer time. If the starting month is after the
ending month, the system assumes that you are in the southern hemisphere.
To disable summer time, use the
configuration command.
This example shows how to set summer time to start on October 12, 2000, at
02:00, and end on April 26, 2001, at 02:00:
AP(config)# clock summer-time pdt date 12 October
2000 2:00 26 April 2001 2:00
By default, 80 is used for HTTP access, and port 443 is used for HTTPS access.
These values can be customized by the user.
Follow these steps to define the HTTP access.
1. From the access point GUI, choose Services > HTTP.
The Service: HTTP-Web server page appears.
2. On this page, enter the desired HTTP and HTTPS port number.
If not values are entered in the port number fields, the default values are
used.
3. Click Apply.
You configure the system name on the wireless device to identify it. By default,
the system name and prompt are
If you have not configured a system prompt, the first 20 characters of the system
name are used as the system prompt. A greater-than symbol (>) is appended. The
prompt is updated whenever the system name changes, unless you manually
configure the prompt by using the
For complete syntax and usage information for the commands used in this
chapter, see the Cisco IOS Configuration Fundamentals Command Reference
and the Cisco IOS IP and IP Routing Command
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Administering the WAP Access
global configuration command
no clock summer-time
.
ap
global configuration command.
prompt
Reference.
Chapter 6
global
235