Cli Configuration Example; Configuring Access Points To Participate In Wids; Configuring The Access Point For Scanner Mode - Allen-Bradley Stratix 5100 User Manual

Chapter 13 Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
Configuring Access Points to
Participate in WIDS
402

CLI Configuration Example

This example shows the CLI commands that are equivalent to the steps listed in
the Configuring Radio Management on page
AP# configure terminal
AP(config)# wlccp wnm ip address 192.250.0.5
AP(config)# end
In this example, the WDS access point is enabled to interact with a WLSE device
with the IP address 192.250.0.5.
For complete descriptions of the commands used in this example, see publication
Cisco IOS Command Reference for Cisco Aironet Access Points and
To participate in WIDS, access points must be configured to participate in WDS
and in radio management.
Follow the steps in the Configuring Access Points to Use the WDS Device on
page 390 and in the Configuring Radio Management on page 400
the access point to participate in WDS and in radio management.

Configuring the Access Point for Scanner Mode

In scanner mode, the access point scans all of its channels for radio activity and
reports the activity to the WDS device on your network. A scanner access point
does not accept client associations.
Beginning in privileged EXEC mode, follow these steps to set the access point
radio network role to scanner:
1. Enter global configuration mode.
configure terminal
2. Enter interface configuration mode for the radio interface.
• The 2.4 GHz radio and the 2.4 GHz 802.11n radio is 0.
• The 5 GHz radio and the 5 GHz 802.11n radio is 1.
interface dot11radio { 0 | 1 }
3. Set the access point role to scanner.
station role scanner
4. Return to privileged EXEC mode.
end
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
400:
Bridges.
to configure