Default Password And Privilege Level Configuration; Setting Or Changing A Static Enable Password - Allen-Bradley Stratix 5100 User Manual

Chapter 6 Administering the WAP Access
Default Password and
Privilege Level Configuration
Setting or Changing a Static
Enable Password
202
This table shows the default password and privilege level configuration.
Table 76 - Default Password and Privilege Levels
Feature
Username and password
Enable password and privilege level
Enable secret password and privilege level
Line password
The enable password controls access to the privileged EXEC mode. The
global configuration command removes the enable
enable password
password, but use extreme care when using this command. If you remove the
enable password, you are locked out of the EXEC mode.
Beginning in privileged EXEC mode, follow these steps to set or change a static
enable password:
1. Enter global configuration mode.
configure terminal
2. Define a new password or change an existing password for access to
privileged EXEC mode.
enable password password
The default password is wirelessap.
For password, specify a string from 1...25 alphanumeric characters. The string
cannot start with a number, is case sensitive, and allows spaces but ignores leading
spaces. It can contain the question mark (?) character if you precede the question
mark with the key combination Crtl-V when you create the password; for
example, to create the password abc?123, do this:
1. Enter abc.
2. Enter Crtl-V.
3. Enter ?123.
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Default Setting
Default username is blank and the default password is wirelessap.
Default password is wirelessap. The default is level 15 (privileged
EXEC level). The password is encrypted in the configuration file.
The default enable password is wirelessap. The default is level 15
(privileged EXEC level). The password is encrypted before it is written
to the configuration file.
Default password is wirelessap. The password is encrypted in the
configuration file.
no