Displaying The Radius Configuration; Radius Attributes Sent By The Access Point - Allen-Bradley Stratix 5100 User Manual

Chapter 14 Configuring RADIUS and TACACS+ Servers
428
This example shows how to configure the WISPr location-name attribute:
ap# snmp-server location
ACMEWISP,Gate_14_Terminal_C_of_Newark_Airport
This example shows how to configure the ISO and ITU location codes on the
access point:
ap# dot11 location isocc us cc 1 ac 408
This example shows how the access point adds the SSID used by the client device
and formats the location-ID string:
isocc=us,cc=1,ac=408,network=ACMEWISP_NewarkAirport

Displaying the RADIUS Configuration

To display the RADIUS configuration, use the
privileged EXEC command.
When DNS is configured on the access point, the
TIP
config

RADIUS Attributes Sent by the Access Point

Table 99 on page 428 through
by an access point to a client in access-request, access-accept, and accounting-
request packets.
You can configure the access point to include in its RADIUS accounting and
TIP
authentication requests attributes recommended by the Wi-Fi Alliance's WISPr
Best Current Practices for Wireless Internet Service Provider (WISP) Roaming
document.
See Configuring WISPr RADIUS Attributes on page 426
Table 99 - Attributes Sent in Access-Request Packets
Attribute ID
1
4
5
12
30
31
32
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
show running-config
a server's IP address can appear instead of its name.
Table 101 on page 429
Description
User-Name
NAS-IP-Address
NAS-Port
Framed-MTU
Called-Station-ID (MAC address)
Calling-Station-ID (MAC address)
(1)
NAS-Identifier
show running-
identify the attributes sent
for instructions.