Configuring Snmp-Server Hosts; Configuring Snmp-Server Users; Configuring Trap Managers And Enabling Traps - Allen-Bradley Stratix 5100 User Manual

Chapter 19 Configuring SNMP
514

Configuring SNMP-Server Hosts

To configure the recipient of an SNMP trap operation, use the following
command in global configuration mode:
snmp-server host host [traps | informs][version {1
| 2c | 3 [auth | noauth | priv]} ] community-string
[udp-port port] [notification-type]

Configuring SNMP-Server Users

To configure a new user to an SNMP group, use the following command in global
configuration mode:
snmp-server user username [groupname remote ip-
address
[udp-port port] {v1 | v2c | v3 [encrypted] [auth
{md5 | sha}
password]] [access access-list]

Configuring Trap Managers and Enabling Traps

A trap manager is a management station that receives and processes traps. Traps
are system alerts that the access point generates when certain events occur. By
default, no trap manager is defined, and no traps are issued.
Access points running this Cisco IOS release can have an unlimited number of
trap managers. Community strings can be any length.
This table describes the supported access point traps (notification types). You can
enable any or all of these traps and configure a trap manager to receive them.
Table 111 - Supported Access Point Traps
Notification Type
authenticate-fail
config
deauthenticate
disassociate
dot11-qos
entity
rogue-ap
snmp
switch-over
syslog
wlan-wep
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
auth-password [priv des56 priv
Description
Enable traps for authentication failures.
Enable traps for SNMP configuration changes.
Enable traps for client device deauthentications.
Enable traps for client device disassociations.
Enable traps for QoS changes.
Enable traps for SNMP entity changes.
Enable traps for rogue access point detections.
Enable traps for SNMP events.
Enable traps for switch-overs.
Enable syslog traps.
Enable WEP traps.