Snmp Error Messages; Ssh Error Messages - Allen-Bradley Stratix 5100 User Manual

SNMP Error Messages

Message
SNMP-3-AUTHFAILIPV6: Authentication
failure for SNMP request from
hostUnrecognized format ' %P'
SNMP-3-INPUT_QFULL_ERR: Packet dropped
due to input queue full
SNMP-3-INTERRUPT_CALL_ERR: "s" function,
cannot be called from interrupt handler
SNMP-4-NOENGINEIDV6: Remote snmpEngineID
for Unrecognized format ' %P' not found when creating
user: "s"
SNMP_MGR-3-MISSINGHOSTIPV6: Cannot
locate information on SNMP informs
host:Unrecognized format ' %P'

SSH Error Messages

Message
SSH-5-SSH2_CLOSE: SSH2 Session from "%s"
(tty = "%d") for user '"%s"' using crypto
cipher '"%s"', hmac '"%s"' closed
SSH-5-SSH2_SESSION: SSH2 Session request
from "%s" (tty = "%d") using crypto
cipher '"%s"', hmac '"%s"' "%s"
SSH-5-SSH2_USERAUTH: User '"%s"'
authentication for SSH2 Session from "%s"
(tty = "%d") using crypto cipher '"%s"',
hmac '"%s"' "%s"
SSH-5-SSH_CLOSE: SSH Session from
"%s"(tty = "%d") for user '"%s"' using
crypto cipher '"%s"' closed
SSH-5-SSH_SESSION: SSH Session request
from "%s" (tty = "%d") using crypto
cipher '"%s"' "%s"
SSH-5-SSH_USERAUTH: User '"%s"'
authentication for SSH Session from "%s"
(tty = "%d") using crypto cipher '"%s"'
"%s"
Explanation
An SNMP request was sent by this host that was not
properly authenticated.
Snmp packet dropped due to input queue full error
This message indicates that a call has been made to the
function from an interrupt handler. This is not permitted
because it fails and device restarts down the stack in
malloc call.
An attempt to create a user failed.This is likely because the
engine ID of the remote agent (or SNMP manager) was
not configured.
A table entry for the mentioned SNMP informs
destination cannot be found. As a result, inform
notifications are not sent to this destination.
Explanation
The SSH Session closure information
The SSH session request information
The SSH user authentication status information
The SSH Session closure information
The SSH session request information
The SSH user authentication status information
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Error and Event Messages Appendix C
Recommended Action
Make sure that the community/user name
used in the SNMP req has been configured on
the router.
Use the command to see the
show snmp
number of packets dropped. Stop any SNMP
access to the device until the error condition
is recovered.
If this messages recurs, copy it exactly as it
appears and report it to your technical
support representative.
Configure the remote snmpEngineID and
reconfigure the user. If the problem persists,
copy the error message exactly as it appears,
and report it to your technical support
representative.
Run the and
show snmp host show
commands. Copy the error message
snmp
and output from the show commands
exactly as they appear, and report it to your
technical support representative. Deleting
and adding again the informs destination via
the
snmp-server host
configuration command can clear the
condition. Otherwise, reloading the system is
necessary.
Recommended Action
No action necessary - informational message
No action necessary - informational message
No action necessary - informational message
No action necessary - informational message
No action necessary - informational message
No action necessary - informational message
593