Displaying The Tacacs+ Configuration; Configuring Ethernet Speed And Duplex Settings - Allen-Bradley Stratix 5100 User Manual

Chapter 6 Administering the WAP Access
Configuring Ethernet Speed
and Duplex Settings
218
3. Configure the wireless device for user TACACS+ authorization to
determine if the user has privileged EXEC access.
The keyword can return user profile information (such as
exec
information).
autocommand
aaa authorization exec tacacs+
4. Return to privileged EXEC mode.
end
5. Verify your entries.
show running-config
6. (Optional) Save your entries in the configuration file.
copy running-config startup-config
To disable authorization, use the
global configuration command.
exec} method1

Displaying the TACACS+ Configuration

To display TACACS+ server statistics, use the show tacacs privileged EXEC
command.
You can assign the wireless device Ethernet port speed and duplex settings. We
recommend that you use
settings on the wireless device Ethernet port. When the wireless device receives
inline power from a switch, any change in the speed or duplex settings that resets
the Ethernet link restarts the wireless device.
If the switch port that the wireless device is connected to is not set to
can change the wireless device port to
mismatch and the Ethernet link is not reset. However, if you change from
or back to , the link is reset and, if the wireless device receives inline
full auto
power from a switch, the wireless device restarts.
The speed and duplex settings on the wireless device Ethernet port must
IMPORTANT
match the Ethernet settings on the port where the wireless device is
connected.
If you change the settings on the port where the wireless device is connected,
change the settings on the wireless device Ethernet port to match.
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
no aaa authorization {network |
, the default setting, for both the speed and duplex
auto
or
half full
, you
auto
to correct a duplex
half