Install The Touch Panel Controller (Tpc) - Christie CP4230 Setup Manual

Prop up rear of projector
1.
2.8

Install the Touch Panel Controller (TPC)

1. Loosen the mounting arm so that the end fits over the ball joint located on the rear panel of the cinema
projector.
2. Tighten the mounting arm until it fits tightly on the joint.
3. Connect the cable from the TPC to the connector on the rear panel of the cinema projector.
4. Adjust the angle of the TPC.
CP4230 Setup Guide
020-100669-03 Rev. 1 (05-2014)
2.
19 mm wrench
Figure 2-7 Using the Foot Extension Rods
Figure 2-8
Figure 2-9
Section 2: Installation and Setup
Remove rear feet
3.
Add foot extension rod
2-9