Touch Panel Controller (Tpc); Position The Projector - Christie CP2210 User Manual

Dlp digital cinema projector
Hide thumbs Also See for CP2210:
Table of Contents

Advertisement

Section 2: Installation and Setup
• OFF: Not detected.
• Red: Detected communication problems etc.
• Green: Detected and working properly.
ICP Faceplate Connections
The ICP board provides the image processing electronics for the projector. The ICP faceplate includes a
number of LEDs that are only functional when the projector is in full power mode.
• REGEN: (Regulators Enabled) This LED indicates the presence of the internal regulator enable signal.
When illuminated BLUE the internal regulators are enabled. When OFF, not enabled.
• SOFTST: (Software State) This LED indicates the state of the software application. When OFF, in a Fail
state (0). When RED, in a Fail state (1). When YELLOW, in a Fail state (2). When GREEN, status OK.
• OSST: (Operating System State) This LED indicates the state of the operating system. When OFF, in a Fail
state (0). When RED, in a Fail state (1), When YELLOW, in a Fail state (2). When GREEN, status OK.
• FMTST: (FMT FPGA State) This LED indicates the configured state of the FMT FPGA. When RED,
unable to configure FPGA with Main or Boot application. When YELLOW, in Boot application. When
GREEN, in Main application.
• ICPST: (ICP FPGA State) This LED indicates the configured state of the ICP FPGA. When RED, unable to
configure FPGA with Main or Boot application. When YELLOW, in Boot application. When GREEN, in
Main application.
• Port A / Port B: Indicates the status of the ICP input port A or B. When OFF, no source is present. When
GREEN, active source present.
• USB 1 / USB 2: For future use.

2.2.10 Touch Panel Controller (TPC)

The TPC is a portable, touch-sensitive screen used to control the projector. It is mounted to the rear of the
projector and can be adjusted at any angle using the flexible double ball joint mount for convenient viewing
and flexible operation in various installation configurations. The TPC provides users with a means for
monitoring operation and status of the projector. Users can turn the lamp ON/OFF, select a specific source/
input and obtain basic status information. Depending on the installation, the TPC can remain mounted to the
projector or wall mounted anywhere else at the site. An optional extension cable is also available, which can be
purchased separately to provide TPC access up to 100 feet away. NOTE: If your system has a TPC-660E check
to ensure the main switch on the back is connected properly. If your system has a TCP-650H it automatically
turns ON when connected.
2.3

Position the Projector

WARNING
when it has been leveled.
1. An optional rack stand (P/N: 108-282101-xx) is available for use with the projector. For installation
instructions, refer to the Rack Stand Installation Instruction Sheet (P/N: 020-100060-xx). NOTES: 1)
When using the rack stand the foot lock brackets are a mandatory safety measure to prevent the projector
from tipping. 2) The rack stand feet are used for leveling only and not for tilting the projector. To prevent
tipping ensure the required accessories supplied by Christie are used.
2-4
Downloaded from ProjectorsManual.com Manuals
2 people are required to safely lift and install the projector.
Auto LampLOC
must be run any time the projector is physically moved or
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)

Advertisement

Table of Contents
loading

Table of Contents