Touch Panel Controller (Tpc); List Of Components - Christie Solaria CP2220 User Manual

• Reset: This button is slightly recessed into the faceplate to prevent accidental activation. It's main purpose is
to reset the electronics of the projector. After re-booting, the projector will return to its previous power mode
(Standby or Full Power), however the lamp will not strike automatically and requires manual striking.
• 3D: Connect a variety of 3D products to this connector, such as MasterImage or Real D for polarizing and
de-ghosting 3D content during projection.
ICP Faceplate Connections
The ICP board provides the image processing electronics for the projector. The ICP faceplate includes a
number of LEDs that are only functional when the projector is in full power mode.
• REGEN: (Regulators Enabled) This LED indicates the presence of the internal regulator enable signal.
When illuminated BLUE the internal regulators are enabled. When OFF, not enabled.
• SOFTST: (Software State) This LED indicates the state of the software application. When OFF, in a Fail
state (0). When RED, in a Fail state (1). When YELLOW, in a Fail state (2). When GREEN, status OK.
• OSST: (Operating System State) This LED indicates the state of the operating system. When OFF, in a Fail
state (0). When RED, in a Fail state (1), When YELLOW, in a Fail state (2). When GREEN, status OK.
• FMTST: (FMT FPGA State) This LED indicates the configured state of the FMT FPGA. When RED,
unable to configure FPGA with Main or Boot application. When YELLOW, in Boot application. When
Green, in Main application.
• ICPST: (ICP FPGA State) This LED indicates the configured state of the ICP FPGA. When RED, unable to
configure FPGA with Main or Boot application. When YELLOW, in Boot application. When Green, in Main
application.
• Port A / Port B: Indicates the status of the ICP input port A or B. When OFF, no source is present. When
GREEN, active source present.

Touch Panel Controller (TPC)

The Touch Panel Controller (TPC) is a portable, touch-sensitive screen used to control the projector. It is
mounted to the rear of the projector and can be adjusted at any angle using the flexible double ball joint mount
for convenient viewing and flexible operation in various installation configurations. In general, the TPC
provides users with a means for monitoring operation and status of the projector. In general, users can turn the
lamp on/off, select a specific source/input, and obtain basic status information.
Depending on the installation, the TPC can remain mounted to the projector or wall mounted anywhere else at
the site. An optional extension cable is also available, which can be purchased separately to provide TPC
access up to 100 feet away.

1.6.4 List of Components

Ensure the following components were received with the projector:
Projector with Touch Panel Controller
Lens plug
(required for shipping when lens is not installed to prevent contamination of critical optical components)
Nylon safety strap with clip
Warranty Card
Web Registration Form
Ensure the following components were received with the Lamp Power Supply (P/N 127-101103-01):
10' line cord (250V/10A)
Harness package (includes 4 cables)
CP2220 User Manual
020-100420-06 Rev. 1 (03-2011)
(required to secure projector to tabletop or optional rack mount)
Section 1: Introduction
1-9