Required tools
The following tools are required to complete the installation.
•
Electrostatic discharge mat
•
Grounded electrostatic discharge wrist strap
•
#1 Phillips screwdriver
•
#2 Phillips screwdriver
•
14 mm wrench or 14 mm deep socket
•
3/16 nut driver
•
7/32 nut driver
•
1/4 socket or wrench
•
2.5 mm hex driver
•
2.5 mm ball driver
Upgrading the projector software
Before installing the faceplate kit, upgrade the projector software to Solaria Main Software v4.8.1(3).
1. On the touch panel controller (TPC), tap Menu > Administrator Setup > Upgrade.
2. Tap Upload.
3. Browse to the location of the software upgrade file.
4. Tap the upgrade file and tap Open.
5. In the Available Upgrade Files list, tap the upgrade file loaded in the previous step.
6. Tap Next.
Retrofitting the Solaria One with the GDC SR-1000 IMB Instruction Sheet
020-102945-03 Rev. 1 (05-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Retrofitting the Solaria One with the GDC SR-1000 IMB
2