Balancer Weight Installation - Suzuki AN400 Service Manual

• In this condition, check the "rim line" A cast on the tire side
walls. The line must be equidistant from the wheel rim all
around. If the distance between the rim line and wheel rim
varies, this indicates that the bead is not properly seated. If
this is the case, deflate the tire completely and unseat the
bead for both sides. Coat the bead with lubricant and fit the
tire again.
• When the bead has been fitted properly, adjust the pressure
to specification.
• As necessary, adjust the tire balance.
$
Do not run with a repaired tire at a high speed.
& Cold inflation tire pressure
Solo riding 175 kPa (1.75 kgf/
Dual riding 175 kPa (1.75 kgf/

BALANCER WEIGHT INSTALLATION

• When installing the balancer weights to the wheel, set the two
balancer weights B on both sides of wheel rim.
$
Weight difference between the two balancer weights
must be less than 10 g (0.02 lb).
Front
200 kPa (2.00 kgf/
cm², 25 psi) cm², 28 psi)
280 kPa (2.80 kgf/
cm², 25 psi) cm², 40 psi)
Rear
CHASSIS 7-81