8-20
ELECTRICAL SYSTEM
SIDE-STAND RELAY INSPECTION
NOTE:
The turn signal/side-stand relay is composed of the turn signal
relay, the side-stand relay and diode.
• Remove the front leg shield. (!7-12)
• Disconnect the turn signal/side-stand relay.
First check the insulation between B and C terminals with the
tester. Then apply 12 V to terminals B and A ( + to B and - to
A) and check the continuity between B and C. If there is no
continuity, replace the turn signal/side-stand relay with a new
one.
# 09900-25008: Multi circuit tester set
+ Tester knob indication: Continuity test (,)
SIDE-STAND RELAY
DIODE
TURN
SIGNAL
RELAY