Suzuki AN400 Service Manual page 94

3-48 ENGINE
• Install the circlip 3.
• Install the needle bearing 4 using the special tool.
% 09913-70210: Bearing installer set (37 × 40 mm)
$
* Position the needle bearing with its punch mark out-
side.
* Apply sufficient grease both to the grease groove
and needle bearing inside the fixed driven face.
" 99000-25010: SUZUKI SUPER GREASE "A" (Others)
99000-25030: SUZUKI SUPER GREASE "A" (USA)
• Install the oil seals 5 to both sides of the movable driven face
6 until the stopper is contacted.
% 09913-70210: Bearing installer set (62 ×68 mm)
$
Replace the oil seal with a new one.
• Install the oil seal 7.
% 09913-70210: Bearing installer set (62 ×68 mm)
$
* Position the oil seal so that the stamped code toward
outside.
* Apply sufficient grease to both the oil seal lips all
around and the grease groove inside the movable
driven face.
* Replace the oil seal with a new one.
" 99000-25010: SUZUKI SUPER GREASE "A" (Others)
99000-25030: SUZUKI SUPER GREASE "A" (USA)