Suzuki AN400 Service Manual page 274

• Remove the rear brake caliper cover 4.
• Loosen the lock nut.
• Remove the brake-lock arm 5 and remove the brake-lock
cable 6.
• Install the brake-lock cable. (!9-19)
• Turn the nut 7 until the clearance is 0mm. (0 in)
• Install the brake-lock cable to the brake-lock lever 8 and
tighten the nut 9.
$
Check that the boot 0 is fitted securely.
• Install the brake-lock arm A. (!7-56)
NOTE:
The open end of spring must face to the left side of vehicle as
shown.
CHASSIS
Clearance
7-63