3-70
ENGINE
STARTER DRIVEN GEAR
• Install the starter driven gear 1 and key 2.
GENERATOR ROTOR
• Install the generator rotor 1.
NOTE:
Make sure to engage the starter clutch with the starter driven
gear.
• Screw the generator rotor nut.
• With the generator rotor locked, tighten the generator rotor
nut to the specified torque.
# Generator rotor nut: 160 N·m (16.0 kgf-m, 115.5 lb-ft)
OIL SUMP FILTER
• Install the O-ring 1 to the oil sump filter cap 2.
$
Replace the O-ring with a new one.
• Insert the oil sump filter 3.
$
* The lip A of the oil sump filter should be positioned
downward.
* The thinner side B of the oil sump filter should be
positioned inside.