Caliper Inspection; Caliper Reassembly And Remounting - Suzuki AN400 Service Manual

• Remove the lock nut 0, brake-lock adjuster A, brake lock
arm B and brake-lock shaft C.

CALIPER INSPECTION

• Inspect the brake fluid leakage from O-ring 1 and cup 2.
• If any damage is found, replace the rear brake caliper with a
new one.
• Inspect the brake caliper cylinder walls and caliper pistons
surface for nicks, scratches and other damage.
• If any damage is found, replace the rear brake caliper with a
new one.

CALIPER REASSEMBLY AND REMOUNTING

• Reassemble and remount the brake caliper in the reverse
order of removal and disassembly.
• Pay attention to the following points:
• Install the new gasket 1.
• Apply THREAD LOCK to the brake-lock housing bolts 2 and
tighten them to the specified torque.
( 99000-32130: THREAD LOCK SUPER "1360"
# Brake-lock housing bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
CHASSIS 7-55