Suzuki AN400 Service Manual page 126

3-80 ENGINE
• Align the engraved line A with the cylinder head top surface.
• Engage the cam chain with the cam sprocket.
• Align the locating pin hole B with the locating pin on the cam-
shaft.
NOTE:
Turn the sprocket little by little moving the cam chain by one link
at a time.
• Apply THREAD LOCK to the cam sprocket bolts.
/ 99000-32030: THREAD LOCK "1303"
• Position the lock washer 4 so that the locating pin on the
camshaft is covered and tighten the cam sprocket bolts to the
specified torque.
# Cam sprocket bolt: 15 N·m (1.5 kgf-m, 11.0 lb-ft)
• Bend up the lock washer to lock the bolts.
• Install the dowel pins 5.
• Apply MOLYBDENUM OIL SOLUTION on the cam faces.
) MOLYBDENUM OIL SOLUTION
• Install the camshaft holder 6, then tighten the camshaft
holder bolts to the specified torque.
# Camshaft holder bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the dowel pins 7.
• Install the camshaft journal holder 8, then tighten the cam-
shaft journal holder bolts to the specified torque.
# Camshaft journal holder bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
$
To install the camshaft journal holder 8, the pro-
truded side D must be positioned outside.