Cam Chain Tension Adjuster; Cylinder Head Cover - Suzuki AN400 Service Manual

CAM CHAIN TENSION ADJUSTER

• With the spring holder bolt and spring removed from the cam
chain tension adjuster, release locking of the ratchet mecha-
nism 1 and push the push rod 2 all the way in.
• Position the cam chain tension adjuster 3 on the cylinder.
• Tighten the cam chain tension adjuster bolts to the specified
torque.
$
Replace the gasket with a new one.
# Cam chain tension adjuster bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the O-ring 4, spring 5 and spring holder bolt 6.
$
Replace the O-ring with a new one.
• Tighten the spring holder bolts to the specified torque.
# Spring holder bolt: 8 N·m (0.8 kgf-m, 5.7 lb-ft)
$
* When the cam chain tension adjuster has been
installed, check for cam chain tension to determine if
the tension adjuster is functioning properly.
* Turn the crankshaft and check that all the moving
parts(e.g., camshaft and the rocker arm)work prop-
erly.
• Inspect the valve clearance. (!2-5)

CYLINDER HEAD COVER

• Install the gasket to the cylinder head cover 1.
$
Replace the gasket with a new one.
• Apply SUZUKI BOND to the cam end cap.
0 99000-31160: SUZUKI BOND "1216"
ENGINE 3-81