Suzuki AN400 Service Manual page 101

• Remove the bearing 2 using the special tool.
% 09921-20240: Bearing remover set (35 mm)
REASSEMBLY
• Reassemble the bearing in the reverse order of removal.
• Pay attention to the following points:
• Install the bearing using the special tool.
% 09913-70210: Bearing installer set (62 × 68 mm)
DRIVE V-BELT INSPECTION
• Check that the drive V-belt is free from any greasy substance.
• Check the contact surface for crack or other damage.
• Measure the width A of the belt using the vernier calipers.
• If the measurement exceeds the service limit or crack or other
damage exists, replace the belt with a new one.
' Dride V-belt width: Service Limit: 20.85 mm (0.82 in)
% 09900-20102: Vernier Calipers
$
If grease or oil is present on the surface, degrease the
belt thoroughly.
ENGINE 3-55