Reassembly - Suzuki AN400 Service Manual

REASSEMBLY

• Reassemble the throttle body in the reverse order of disas-
sembly.
• Pay attention to the following points:
• Set the idle adjust screw 1 to the original position (amount of
turning back) where it was set before disassembly.
#
Replace the O-ring with a new one.
• Apply thin coat of the engine oil to the new O-ring.
• Install the O-ring 2 to the throttle body.
#
Replace the O-ring with a new one.
• Install the injector seal 3 and O-ring 4 to fuel injector.
• Apply thin coat of the engine oil to the new O-ring and new
seal.
• Install the fuel injectors by pushing them straight to throttle
body.
#
Replace the injector seal and O-ring with the new
ones. Never turn the injector while pushing it.
• Apply a small quantity of SUZUKI SUPER GREASE to the
shaft end and seal lip.
' 99000-25010: SUZUKI SUPER GREASE "A" (Others)
99000-25030: SUZUKI SUPER GREASE "A" (USA)
FUEL SYSTEM AND THROTTLE BODY 5-19