Camshaft - Suzuki AN400 Service Manual

CAMSHAFT

CAM WEAR INSPECTION
• Check the sliding surface for extraordinary.
• Measure the cam height H with a micrometer.
• If the service limit has been exceeded,replace the camshaft.
' Cam height H: Service Limit: (IN) 33.13 mm (1.30 in)
% 09900-20202: Micrometer (25 – 50 mm)
CAMSHAFT JOURNAL WEAR INSPECTION
• Place the plastigauge between the camshaft 1 and camshaft
holder and tighten the camshaft holder bolt to the specified
torque.
% 09900-22301: Plastigauge
09900-22302: Plastigauge
# Camshaft holder bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
Do not rotate the camshaft after the camshaft holder has been
tightened with the plastigauge in place.
• Remove the camshaft holders and read the width of the com-
pressed plastigauge with envelope scale.
• This measurement should be taken at the widest part.
' Camshaft journal oil clearance:
Service Limit: (*22)
(*17.5) 0.15 mm (0.006 in)
(EX) 33.00 mm (1.30 in)
0.15 mm (0.006 in)
ENGINE 3-35