Suzuki AN400 Service Manual page 93

CLUTCH SHOE INSPECTION
• Check the boss and centrifugal weight fulcrum sections for
looseness,damage and operation.
• Check the clutch shoe for damage and fouling with oil on the
surface.
• Measure the thickness of clutch shoe at the center position. If
the thickness is smaller than the the service limit, replace the
shoe assembly with a new one.
' Clutch shoe thickness: Service Limit: 2.0 mm (0.08 in)
% 09900-20102: Vernier calipers
MOVABLE DRIVEN FACE SPRING INSPECTION
• Measure the spring free length using the vernier calipers.
• If the length is shorter than the service limit, replace the spring
with a new one.
' Movable driven face spring free length:
Service Limit: 118.7 mm (4.67 in)
% 09900-20102: Vernier calipers
REASSEMBLY
• Reassembly the clutch shoe/movable driven face in the
reverse order of disassembly.
• Pay attention to the following points:
• Install the bearing 1 to the fixed driven face 2 using the spe-
cial tool.
% 09913-70210: Bearing installer set (32 × 35 mm)
$
Position the sealed side of the bearing toward out
side.
ENGINE 3-47