3-68
ENGINE
• Fit the balancer shaft key 7 into key way.
• When installing the balancer driven gear 8, align the punch
mark C on the balancer drive gear with the punch mark D on
the balancer driven gear.
• Insert a steel rod into the scissors gear through the balancer
driven gear and let the balancer driven gear teeth mesh with
the balancer drive gear teeth.
$
Make sure that the punch mark E on the balancer
drive gear is aligned with the punch mark F on the
balancer driven gear.
• Install the washer 9 and balancer driven gear nut 0.
• Lock the crankshaft by inserting a steel rod and tighten the
balancer driven gear nut to the specified torque.
# Balancer driven gear nut: 50 N·m (5.0 kgf-m, 36.0 lb-ft)
STARTER IDLE GEAR
• Install the starter idle gear 1 onto the starter idle gear shaft
2.