Transmission/Transmission Cover; Clutch Shoe/Movable Driven Face Assembly - Suzuki AN400 Service Manual

3-72 ENGINE

TRANSMISSION/TRANSMISSION COVER

• Install the O-ring 1.
• Apply a small amount of engine oil to the O-ring 1.
$
Replace the O-ring with a new one.
• Install the washer 2.
• Install the dowel pins 3.
• Install the transmission cover 4.
$
* Be careful not to drop the driveshaft washer inside
during assembly.
* Also take care not to allow the O-ring to be pinched.
# Transmission cover bolt: 22 N·m (2.2 kgf-m, 16 lb-ft)
CLUTCH SHOE/MOVABLE DRIVEN FACE
ASSEMBLY
• With the clutch shoe spring compressed by pulling the mov-
able driven face toward the clutch, install the drive V-belt 1 to
the movable driven face 2.
$
* Position the drive belt so that the arrow A points the
engine rotating direction.
* Degrease the drive belt contact surface (pulley face).