3-54
ENGINE
• Remove the springs 5.
• Remove the scissors gear 6.
REASSEMBLY
• Reassemble the scissors gear in the reverse order of disas-
sembly.
• Pay attention to the following points:
• Assemble the scissors gear with its stamp mark side A facing
inside.
• When assembling, align the balancer driven gear hole B with
the scissors gear hole C.
• Install the springs 1.
• Install the washers 2, 3 and spring washer 4.
• Install the circlip 5.
$
Install the spring washer 4 with the convex side fac-
ing outside.
CLUTCH HOUSING INSPECTION
• Check for any abnormal surface damage.
• Measure the inside diameter of the clutch housing.
• If the measurement exceeds the service limit, replace the
housing with a new one.
' Clutch housing I.D.: Service Limit: 135.5 mm (5.33 in)
CLUTCH INNER COVER
DISASSEMBLY
• Remove the bearing retainer 1.