Inner Clutch Cover Bearing Inspection; Inner Clutch Cover Bering Removal And Installation - Suzuki AN400 Service Manual

Inner Clutch Cover Bearing Inspection

Inspect the play of the inner clutch cover bearings by
finger while they are in the inner clutch cover. Rotate the
inner race by finger to inspect for abnormal noise and
smooth rotation. Replace the bearing in the following
procedures if there is anything unusual. Refer to "Inner
Clutch Cover Bering Removal and Installation (Page5A-
7)".
Inner Clutch Cover Bering Removal and
Installation
Removal
1) Remove the inner clutch cover. Refer to "V-belt Type
Continuously Variable Automatic Transmission
Removal and Installation (Page5A-3)".
2) Remove the bearing retainers (1).
3) Remove the bearing (2) using the special tool.
Special tool
(A): 09921–20240 (Bearing remover set)
(A)
B705H15106013
I649G1240015-01
B705H15106014
1
I705H1510069-01
2
I705H1510070-02
Automatic Transmission:
Installation
Install the bearing in the reverse order of removal. Pay
attention to the following points:
CAUTION
!
The removed bearing must be replaced with
the new ones.
• Apply grease to the bearing and inner clutch cover
side.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the bearing to the inner clutch cover using the
special tool.
CAUTION
!
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09913–70210 (Bearing installer set)
(A)
5A-7
I649G1240019-01
I705H1510071-01